Job Details

Staff Engineer - 816 USA:TX:Tyler | Engineering | Full-TimeSummary The Staff Engineer will perform conceptual design, detailed engineering, equipment fabrication, testing, and start-up, review the project contract, proposal, specifications, preliminary drawings, and clarifications to determine the intended scope, technical feasibility, and compliance of technical objectives for the project.Responsibilities Upon full time employment with PW the Staff Engineer will be required to immediately begin self-study in the field of centrifugal pump design as a prerequisite to begin designing impellers, case volutes, diffusers, and re-rating pumps to meet specific design conditions and performance characteristics. Initial job requirements will be as follows:Perform trim analysis as required for the PW Remanufacturing and PW610 manufacturing facilitiesPerform thrust load analysis as required for the PW Remanufacturing and PW610 manufacturing facilities as requiredMap pump case volutes and volute sectional areas as required and produce detail drawings of eachCollect critical hydraulic dimensions for existing impellers as requiredCreate volute modification drawings using new design data provided by the Assistant Engineering Manager/Hydraulics EngineerCreate case throat area drawings as required and create modified throat area drawings using new design data provided by the Assistant Engineering Manager/Hydraulics EngineerManage pump case volute modifications and impeller modifications performed by shop personnel as required by the Assistant Engineering ManagerGenerate 3D models of pump hydraulic components using SolidworksCreate fluid models using Solidworks which will be used for CFD analysisQualifications Must Have a Bachelor of Science in Mechanical Engineering from an accredited university programProficiency with SolidWorks, SolidWorks 2D and/or DraftSightExcel or other spread sheet program capabilitiesGood verbal and communicative skills Additional Information Physical Demand: N/AWorking Conditions: Engineering officeTraining/Certifications: SolidWorks and Excel skills is a plus.Shift Time/Overtime: 7:00 AM - 4:30 PM M-F, there are occasions when they will have to work some overtime depending on the urgency of the project they are working on and/or to provide technical support to our manufacturing facilities, sales, and customers.Travel: Periodic travel to our manufacturing facilities, customer facilities, field serviceEducation: Must have a minimum of a Bachelor of Science in Mechanical Engineering from an accredited university programLocation: USA:TX:TylerMinimum Required Salary and benefits commensurate with experience. We are an equal opportunity employer. Except where prohibited by state law, all offers of employment are conditioned upon successfully passing a drug test. This employer uses E-Verify. EOE/M/F/D/V#J-18808-Ljbffr